TAM胶粘剂中铅镉汞铬砷有害元素的同时测定

研究了HF +HCl消解样品 ,试液用ICP -AES法同时测定TAM胶粘剂中铅、镉、汞、铬、砷的新方法。在选定的最佳条件下测铅、镉、汞、铬、砷的检出限分别为 0 .0 0 15、0 .0 0 0 8、0 .0 0 11、0 .0 0 17、0 .0 0 0 9μg·L- 1 ,回收率为 93 .5 %～ 10 8.3 % ,RSD为 0 .62 %～ 5 .65 %。该法准确、快速、简便 ,应用于TAM胶粘剂的测定 ,结果满意     

Amphoteric water‐soluble copolymer for barium titanate slurries. I. Synthesis and dispersing ability

An amphoteric water‐soluble copolymer, polyacrylamide/[α‐N,N‐dimethyl‐N‐(3‐(β‐carboxylate)acrylamino)propyl] ammonium ethanate (PAM/DAE) was synthesized and used as a dispersion agent for BaTiO₃ particles. PAM/DAE was prepared from acrylamide and [α‐N,N‐dimethyl‐N‐(3‐(β‐carboxylate)acrylamino)propyl] ammonium ethanate in a basic condition through a free‐radical polymerization. The structure of this copolymer was verified by IR and ¹H‐NMR spectra. The dispersing effects of PAM/DAE were examined by measuring the viscosity and sedimentation of BaTiO₃ suspensions, and by analyzing the particle size. The results indicate that this copolymer could uniformly disperse the particles, and the resulting suspensions were less viscous, more stabilized, and contained powder with smaller particle size. The dispersing/stabilizing ability of PAM/DAE is close to, or slightly better than, that of a commercial dispersant, ammonium salt of poly(methacrylic acid). © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 96: 1443–1450, 2005     

1，1，3-三甲基-3-苯基茚满的催化合成木

本文研究了在酸性离子液体的催化作用下α-甲基苯乙烯二聚合成1,1,3-三甲基-3-苯基茚满。实验结果表明,在无溶剂的条件下室温离子液体（CH3CH2）3NHCl-AlCl3对该反应具有很高的催化活性和目标产物的选择性,反应进行到5min即可达到100%的α-甲基苯乙烯转化率和97%的环状二聚物1,1,3-三甲基-3-苯基茚满的选择性。     

基于时间冗余的显著测量误差处理方法

提出基于时间冗余的不可删显著误差处理方法。对于该类特殊变量，采用线性回归的方法，根据历史数据进行预测，进而代替实际到量值进行协调运算。大大降低显著误差对协调数据的污染，确保协调物度。通过实例数据仿真计算证实该方法的有效性。     

腐植酸物质对盐碱化中低产田土壤理化性质及玉米影响的研究

通过田间试验探讨了复合改良制剂、草炭、风化煤等腐植酸类物质施用对盐碱化中低产田土壤理化性质及生长作物的影响，结果表明：复合改良制剂、草炭、风化煤施用对土壤理化性质均有积极的影响，与对照相比达到显著水平。玉米产量的方差分析表明，复合改良制剂处理与草炭、风化煤等处理差异显著，与对照差异极显著，增产率均达到30．67％以上。     

A ratiometric fluorescent sensor for zinc(II) with high selectivity

Spectroscopic studies revealed that the compound [N,N′-di(quinoline-2-methylene) -1,2-phenylenediimine] (1) exhibited a rather high selectivity toward Zn²⁺ over other metal ions, even Cd²⁺. In acetonitrile, the red shift of fluorescent emission from 396 nm to 426 nm upon zinc binding is due to the formation of a 1:1 metal/ligand complex.     

新型高效水处理剂的研制

本文简单介绍了2－丙烯酰胺－2－甲基丙磺酸（AMPS）的性能及应用，工业循环冷动水处理中阻垢剂的发展历史与最新进展。并首次以马来酸酐（MA）、AMPS、NaH2PO2为单体，水为溶剂、过硫酸氨为引发剂合成低磷含量的膦羧酸共调聚物，探讨了单体配比为n(MA):n(AMPS)=2:1,m(NaH2PO2):m(MA AMPS)=10:100时反应温度，反应时间对合成产品的影响。     

有机硅骨架阴离子交换树脂的合成及应用

以等摩尔的γ-氨丙基三乙氧基硅烷与γ-氯丙基三乙氧基硅烷于140℃反应12 h,脱盐后再与1.2倍摩尔的γ-氯丙基三乙氧基硅烷150℃反应16 h,得叔胺硅氧烷预聚物,该预聚物在甲苯-甲醇-水混合溶剂中进一步聚合成含N高度交联的有机硅聚硅氧烷树脂骨架.骨架与溴乙烷在120℃的封管反应20 h,生成强碱性阴离子交换树脂(PNC树脂),交换量可达1.55 mmol·g-1.该树脂用碳酸氢根转型后于固定床反应器中在95℃、1.2 MPa、环氧乙烷与水摩尔比18、空速1.0h-1下催化环氧乙烷水合反应,连续运行72 h,环氧乙烷转化率可达96.9%,乙二醇选择性可达97.1%;交换容量损失率小于2%,溶胀率为零.     

宝浪油田地层结垢机理研究

对宝浪油田地层结垢倾向进行了理论分析,对宝浪油田地层结垢机理进行了静态试验研究.     

A novel synthesis method for the preparation of aromatic poly(imide benzoxazole) from trimellitic anhydride chloride and bis(o‐aminophenol)

A poly(imide benzoxazole) was prepared directly from trimellitic anhydride chloride and 2,2‐bis(3‐amino‐4‐hydroxyphenyl)hexafluoropropane (BisAPAF) monomers in a two‐step method. In the first step, a poly(hydroxyamide amic acid) precursor was synthesized by the low‐temperature solution polymerization in an organic solvent. Subsequently, thermal cyclodehydration of the poly(hydroxyamide amic acid) precursor at 350°C produced the corresponding poly(imide benzoxazole). The inherent viscosity of the precursor polymer was 0.22 dL/g. The cyclized poly(imide benzoxazole) showed a glass transition temperature (T_g) at 329°C and a 5% weight loss temperature at 530°C in nitrogen and at 525°C in air. The poly(imide benzoxazole) is amorphous as evidenced by the wide‐angle X‐ray diffraction measurement. The structures of the precursor polymer and the fully cyclized polymer were characterized by Fourier transform infrared (FTIR) and proton nuclear magnetic resonance spectroscopy (¹H NMR). © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 88: 2388–2391, 2003